y do it

[oli]

http://i.imgur.com/zGRkMgo.png

y just y

if there is some obvious way around this i will love whoever tells me it xx

Thread moved by Samanfa (Forum Moderator): From Bobba as it is better suited here.

[Scotland]

Hey,

i would use some magic stack tiles to alter height on the 3 taller ones,
like put them down a notch, or to smallest they go and use stack tool to find correct height.

[FlyingJesus]

If you mean the platforms being uneven it's because the 2nd/3rd/4th up aren't just double/triple/quadruple the size of the bottom one. If it's a furni that you click to raise the height then just don't do it that way, stack 4 separately for the highest then take the lower 3 out (you won't see the gap anyway) and do the same and down until you only have the 1 at the bottom and they should be the same height using the same amount of furni

[oli]

ok explain again in simple steps 123 pls

[FlyingJesus]

4 platforms, stacked on top of each other in the corner where it's highest
Take the bottom 3 away leaving just one that's 4 platforms high, and then stack those 3 where the next level is
Take the bottom 2 away and have them where the 2nd lowest should be
Take the bottom 1 away and put it where the ground-level one is
Do the side with the smaller pieces as you have done which will cover any gaps by itself

[oli]

oh i get it,
but why would they make the size not scale according to the suited dividers

[FlyingJesus]

Some men just want to watch the world burn

[Bails]

Ugh, so annoying. ._.

[Daltron]

thats so bad lmao aw