new router problem +rep

[Hiro]

ok.

look about in your settings for the three things I listed above.
Enable them, and it should work.

I have a belkin, so I cannot direct you on where to look for them.

[Swearwolf]

ok thank u very much, +rep

edit: cant find settings for it anywhere, apparently its plug and play

[N!ck]

On your PC go to Start > Run (or press "window" key + r) > Type "cmd" and press enter > Type "ipconfig /all" and post the results here.

[Swearwolf]

[N!ck]

Hmm ok, all seems fine. Have you tried using a different ethernet port. Are there any lights on the router and to they flash on the one the 360 is plugged into?

Just found this on a website:

1. Go on the Dashboard of your Xbox 360 console to “System” area then “Network Settings” then “Restore To Factory Defaults" and when it ask you to apply settings select "test Xbox Live"
2. Turn the router off then turn it back on after couple of seconds, by that I mean to unplug it from the wall socket then reconnect it back.
3. If it's a Wired connection Just try once more to "Test Xbox Live Connection"
4. If it's still not working, set the DNS (primary & secondary) with the same number of the Gateway on the IP settings, then go on the Dashboard of your Xbox 360 console to “System” area then “Network Settings” then "Edit Settings" you'll find the gatway on the IP settings put it the same on the Primary & secondary DNS.
5. If it's not working still, then you have to go to your PC and get the DNS Server Address from there as mentioned before, and set it manually on the Dashboard.

[Swearwolf]

afraid not, always fails at the IP check.

[N!ck]

You tried manually putting the DNS and all that info into the 360? (The info you got from ipconfig).

[Swearwolf]

Yep. no difference in the error.

IP routing enabled..................no

could that mean anything?

[N!ck]

Yep. no difference in the error.

IP routing enabled..................no

could that mean anything?

Don't know, try it?

[Swearwolf]

no difference